Siemens TC35i Terminal User Manual

TC35i AT Command Set
13.3 AT^SSTGI
s
m obil e
TC35i_ATC_V02.07 Page 339 of 439 1/30/04
Confidential / Released
13.3 AT^SSTGI SAT Get Information
Regularly this command is used upon receipt of an URC "^SSTN" to request the parameters of the Proactive
Command.
Then the TA is expected to acknowledge the
AT^SSTGI response with AT^SSTR to confirm that the Proactive
Command has been executed.
AT^SSTR will also provide any user information, e.g. a selected menu item.
The Proactive Command type value specifies to which "
^SSTN" the command is related.
Syntax
Parameter Description
TC35i Remote-SAT interface states
0 RESET
1OFF
2IDLE
3PAC
4WAIT
Test Command
AT^SSTGI=?
Response(s)
^SSTGI:(list of supported <state>s), (list of supported <cmdType>s)
OK
Read Command
AT^SSTGI?
Response(s)
^SSTGI: <state>, <cmdType>
OK
Write Command
AT^SSTGI=<cmdType>
Response(s)
OK
PIN ASC0 MUX1 MUX2 MUX3
! % % % %
Reference(s)
SIEMENS
<state>
(num)

Siemens TC35i Terminal Specifications

General

Brand	Siemens
Model	TC35i Terminal
Category	Modem
Language	English