TC35i AT Command Set
7.17 ATO
s
m
obil
e
TC35i_ATC_V02.07 Page 164 of 439 1/30/04
Confidential / Released
7.17 ATO Switch from command mode to data mode
Syntax
Command Description
ATO is the corresponding command to the +++ escape sequence: When you have established a CSD call and
TA is in command mode,
ATO causes the TA to resume the data connection and takes you back to data mode
mode.
Parameter Description
[0] Switch from command mode to data mode
Exec Command
ATO[<n>]
Response(s)
If connection is not successfully resumed:
NO CARRIER
or
TA returns to data mode from command mode
CONNECT <text>
Note: <text> output only if ATX parameter setting with value > 0.
PIN ASC0 MUX1 MUX2 MUX3
! % % ! !
Reference(s)
V.25ter
<n>
(num)
To Next Page
Loading...
Need help?
General
