TC35i AT Command Set
16.6 AT^SSYNC
s
m
obil
e
TC35i_ATC_V02.07 Page 407 of 439 1/30/04
Confidential / Released
16.6 AT^SSYNC Configure SYNC Pin
The AT^SSYNC command serves to configure the SYNC pin of the application interface. The applicability of the
different types of
<mode> is product dependent:
• If you have a TC35i module you may select either mode, depending on whether your application is designed
to use the SYNC mode (indicates the current consumption in a transmit burst) or the LED mode (drives a
status LED connected to the pin). See [2] for further details on both modes.
• In the case of the TC35i Terminal the
AT^SSYNC command is intended only to control the status LED placed
on the front panel. Therefore, the SYNC mode (
<mode>=0) is not applicable. Further details on the LED can
be found in [6].
Syntax
Test Command
AT^SSYNC=?
Response(s)
^SSYNC:list of supported <mode>s
OK
Read Command
AT^SSYNC?
Response(s)
^SSYNC:<mode>
OK
Write Command
AT^SSYNC=<mode>
Response(s)
OK
PIN ASC0 MUX1 MUX2 MUX3
! % % % %
Reference(s)
SIEMENS
To Next Page
Loading...
Need help?
General
