TC35i AT Command Set
5.6 AT+CPWD
s
m
obil
e
TC35i_ATC_V02.07 Page 129 of 439 1/30/04
Confidential / Released
EXAMPLE 2
To set password used to enable or disable barring of all outgoing calls:
EXAMPLE 3
Handling of the "PS" lock password
EXAMPLE 4
To specify a new "PS" lock password, after the old password was disabled (e.g. after three failed attempts to
change the "PS" password): use the master phone code.
CAUTION: THIS TEST SHOULD BE PERFORMED ONLY IF THE CORRECT MASTER PHONE CODE FOR
THE INDIVIDUAL ME USED IS DEFINITELY AVAILABLE! Otherwise the module used will be rendered use-
less until the correct master phone code is entered!:
Alternatively, without giving a new password:
AT+CPWD="AO","0000","3333"
Requests the network to change the password for
supplementary service "call barring".
Ususally this request will affect all barring services,
even though the request is issued for Supplementary
Service BAOC ("Barring of all outgoing calls") only.
Refer to the respective network provider for detail.
OK
AT+CMEE=2
Enable text output of CME Error information
AT+CPWD="PS","1111","2222"
(where "1111" = old password and "2222" = new
password)
OK
Password for facility "PS" is now "2222"
AT+CPWD="PS","1111","2222"
Repeat command to provoke error "incorrect pass-
word"
+CME ERROR: incorrect password
("1111" is no longer the correct password)
AT+CPWD="PS","12345678","1111"
where 12345678 is the Master Phone Code and
1111 is the new password. You may also use
<new
password>
to restore the former disabled pass-
word.
OK
AT+CPWD="PS","12345678"
(where 12345678 is the Master Phone Code). Deac-
tivates the present phone lock.
OK
To Next Page
Loading...
Need help?
General
