363
Setting the Box
Configuration
Setting a Switcher Bank/Multi
Viewer
In a multiple-box switcher configuration, you can
configure a hardware block for use as a switcher bank or
as a multi viewer.
The supported hardware blocks are given below.
• When the system signal format is 2160P
M/E box: Block 1, 2
Cross-point box: Block 1
• When the system signal format is 1080P or 1080i
M/E box: Block 1, 2, 3, 4
Cross-point box: Block 1, 2
1
Open the Home > Setup > System > Format/Config >
Box Config menu (19101.24).
2
Select a tab (Logical Box ID 1 to Logical Box ID 5)
to switch the target to set.
3
In the [Box Config] group, select whether the
hardware block is used as a switcher bank or as a
multi viewer for each block.
M/E: E
nable a switcher bank.
Enhanced MV: E
nable an enhanced multi viewer.
Standard MV: E
nable a standard multi viewer.
• An enhanced multi viewer cannot be set to the
f
ollowing.
– When the system signal format is 2160P: M/E
box b
lock 2
– When the system signal format is 1080P or 1080i:
M/E
box block 3, 4
• A standard multi viewer cannot be set to the
f
ollowing.
– When the system signal format is 2160P: M/E
box b
lock 1 and cross-point box
– When the system signal format is 1080P or 1080i:
M/E
box block 1, 2 and cross-point box
4
Press the [Apply] button.
To return to the previous setting
Press the [Clear] button.
5
Check the message, then press [OK].
The switcher system reboots.
Setting M/E split
You can split an M/E hardware block (physical M/E
block) of the switcher for use as two sub blocks.
You can assign a logical M/E to each sub block.
For details about assigning a logical M/E, see “Assigning
a logical M/E” (page 387).
• Enabling M/E split will disable multi program 2 mode.
• When M/E split is enabled, the Out5 to Out8 outputs
cann
ot be used.
• When M/E split is enabled, the keys that can be used in
a si
ngle physical switcher block can be assigned to the
two sub blocks. You can set the number of keys to
assign.
For details about setting keys, see “Setting sub block
full keys” (page 387).
1
Open the Home > Setup > System > Format/Config >
Box Config menu (19101.24).
2
Select a tab (Logical Box ID 1 to Logical Box ID 5)
to switch the target to set.
3
Select the [M/E Split] switch for the target physical
M/E block to the on state.
To disable M/E split, set the [M/E Split] switch to the
off st
ate.
4
Press the [Apply] button.
To return to the previous setting
Press the [Clear] button.
5
Check the message, then press [OK].
The switcher system reboots.
Setting a GPU
The DME and SL key functions use a GPU.
When the system signal format is 2160P, either the DME
f
unction or SL key function can be enabled.
To use the DME function, the MZS-X1610 3D DME
Li
cense (option) is required. To use the SL key function,
the MZS-X1620 SL Key License (option) is required.
1
Open the Home > Setup > System > Format/Config >
GPU Config menu (19101.25).
Notes
Notes
Note
To Next Page
Loading...
Need help?
General
