2. Maintenance Information
2-4
Gear Oil
Inspection
Check gear oil if leaking.
Park the motorcycle with main stand on flat level
place.
Turn off engine and remove the gear oil draining
plug.
Place a measurement cup under the draining hole.
Check gear oil if enough.
Replacement
At first, remove the gear oil refilling bolt, and then
remove the draining plug. Install the draining plug
after drained oil out.
Torque value: 0.8~1.2kgf-m
Caution
z Inspect if washer is in good condition.
Replace it with new one if it was deformed or
damaged.
Check if the seal washer is good, and replace it if
deformed or damaged.
Torque value: 1.0~1.4 kgf-m
Quantity: HU10U/W 100 c.c.
HU05U 90 c.c.
Recommended: King-Mate HYPOID GEAR OIL
( #140 ).
Fuel System
Fuel Lines
Remove trunk, side cover, central cover, body
frame cover, and pedal, as well as front glove box
Check all lines, and replace it when they are
deterioration, damage or leaking
Warning
z Gasoline is a low ignition material so any kind
of fire is strictly prohibited as dealing.
Oil draining bolt
Oil refilling bolt
To this chapter contents
To Next Page
Loading...
Need help?
General
