2. Maintenance Information
2-15
Battery
Battery Removal
Open the seat cushion and then the battery cap.
(2 screws)
Battery cables removal:
1. At first, remove the negative “-“ cable.
2. Then, remove the positive “+” cable
3. Remove the battery.
If there is some rust on battery posts, clean it with
steel brush.
Install the battery in the reverse procedures of
removal.
Caution
z If there is rust on the posts very serious,
spray some hot water on the posts. Then,
clean it with steel brush so that can remove
rust for more easily.
z Apply some grease on the posts after rust
removed to prevent from rust again.
Headlight Adjustment
Turn on main switch
Turn the headlight adjustment screw to adjust
headlight beam height.
Caution
z To adjust the headlight beam follows related
regulations.
z Improper headlight beam adjustment will
make in coming driver dazzled or insufficient
lighting.
Nuts、Bolts Tightness
Perform periodical maintenance in accord with the
Periodical Maintenance Schedule
Check if all bolts and nuts on the frame are
tightened securely.
Check all fixing pins, snap rings, hose (pipe)
clamps, and wire holders for security.
Headlight adjustment screw
To this chapter contents
To Next Page
Loading...
Need help?
General
