Sym Mio 50 User Manual

2. Maintenance Information
2-14
BRAKE LAMP SWITCH
The brake light switch lit up brake light as brake
applied.
Make sure that electrical starter can be operated
only under brake applying.
Wheel / Tire
Check if the tire pressure of front & rear wheel is
within standard.
Caution
z Tire pressure check should be done as cold
tire.
Appointed tire pressure (HU05U)
Tire size Front tire Rear tire
Single 1.5 2.25
Tire pressure
as cold tire
(Kg/cm²)
Two persons 1.5 2.50
Appointed tire pressure (HU10U/W)
Tire size Front tire Rear tire
Single 1.75 2.25
Tire pressure
as cold tire
(Kg/cm²)
Two persons 1.75 2.50
Appointed Tire:
HU05U Front/Rear wheel: 3.00-10/ 90-90 10
HU10U/W Front & Rear wheel: 90/90 50J
Check if tire surface is ticked with nails, stones or
other materials.
Check if tire surface or wall for crack or damaged,
and replace it if necessary.
The tire tread depth can be checked by visual
inspection or depth gauge.
• Replace the tire if tire tread dent or unusual
wearing out.
• The tire should be replaced if the wear limit
mark “△” is in visible.
Measure tire thread depth from tire central
surface.
Replace the tire if the depth is not come with
following specification:
Front tire：1.5 mm
Rear tire：2.0 mm
Caution
z The wear limit marks “△” are located around
the tire wall even for inspection.
Rear brake light
switch
“△”mark
Brake light switch-
front disc brake
Wear limit indictor
To this chapter contents

Sym Mio 50 Specifications

General

Brand	Sym
Model	Mio 50
Category	Scooter
Language	English