Z13951
Example:
D26601
Example:
CORRECT
WRONG
B01546
Example:
01–12
–INTRODUCTION REPAIR INSTRUCTION
12Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
(e) FRONT SEAT AIRBAG ASSEMBLY
(1) Always store a removed or new front seat airbag assembly with the airbag inflation direction fac-
ing upward. Placing the airbag assembly with the airbag inflation direction facing downward
could cause a serious accident if the airbag inflates.
(2) Never measure the resistance of the airbag squib (This may cause the airbag to inflate, which
is very dangerous).
(3) Grease should not be applied to the front seat airbag assembly, and the airbag door should not
be cleaned with detergents of any kind.
(4) Store the airbag assembly where the ambient temperature remains below 93°C (200° F), without
high humidity and away from electrical noise.
(5) When using electric welding, first disconnect the airbag connector (2 yellow pins) installed on the
assembly before starting work.
(6) When disposing of a vehicle or the side airbag assembly alone, the airbag should be deployed
using an SST before disposal (See page 60–50).
Perform the operation in a safe place away from electrical noise.
To Next Page
Loading...
Need help?
General
