6007X–01
H41550
60–62
–SUPPLEMENTAL RESTRAINT SYSTEM SIDE AIR BAG SENSOR ASSY RH
2445Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
REPLACEMENT
HINT:
COMPONENTS: See page 60–61
1. PRECAUTION(See page 60–1)
2. DISCONNECT BATTERY NEGATIVE TERMINAL(See page 60–1)
3. REMOVE FRONT DOOR SCUFF PLATE RH
(See page 71–12)
4. REMOVE REAR DOOR SCUFF PLATE RH
(See page 71–12)
5. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
(See page 61–7)
6. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
(See page 61–7)
7. REMOVE CENTER PILLAR GARNISH LOWER RH
(See page 61–7)
8. REMOVE FRONT SEAT OUTER BELT ASSY RH
(See page 61–7)
9. REMOVE SIDE AIR BAG SENSOR ASSY RH
(a) Disconnect the connector from the side airbag sensor
assy RH.
(b) Remove the 3 bolts and side airbag sensor assy RH.
10. INSPECT SIDE AIR BAG SENSOR ASSY RH
(See page 60–9)
11. INSTALL SIDE AIR BAG SENSOR ASSY RH
(a) Install the 3 bolts and side airbag sensor assy RH.
Torque: 20 N⋅m (204 kgf⋅cm, 15 ft⋅lbf)
(b) Connect the side airbag sensor connector.
NOTICE:
Installation of the connector is done with the sensor assembly installed. Make sure the sensor
assembly is installed with the specified torque.
If the sensor assembly has been dropped, or there are cracks, dents or other defects in the
case, bracket or connector, replace the sensor assembly with a new one.
When installing the sensor assembly, take care that the SRS wiring does not interfere with other
parts and is not pinched between other parts.
After installation, shake the sensor assembly to check that there is no looseness.
To Next Page
Loading...
Need help?
General
