5105S–01
F40531
SST
C92274
F41595
Matchmarks
–POWER STEERING RACK & PINION POWER STEERING GEAR ASSY
51–29
2296Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
OVERHAUL
NOTICE:
When installing , coat the parts indicated by the arrow with power steering fluid or molybdenum disul-
fide lithium base grease (See page 51–26).
1. PRECAUTION(See page 51–1)
2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. REMOVE HORN BUTTON ASSY
(See page 50–9, 50–22)
4. REMOVE STEERING WHEEL ASSY
(See page 50–9, 50–22)
SST 09950–50013 (09951–05010, 09952–05010, 09953–05020, 09954–05021)
5. REMOVE FRONT WHEEL
6. REMOVE SPIRAL CABLE SUB–ASSY
(See page 50–9, 50–22)
7. DISCONNECT TIE ROD ASSY LH
(a) Remove the cotter pin and nut.
(b) Using SST, remove the tie rod assy LH from the steering
knuckle.
SST 09628–62011
8. DISCONNECT TIE ROD ASSY RH
SST 09628–62011
HINT:
Remove the RH side by the same procedures with LH side.
9. DISCONNECT STEERING INTERMEDIATE SHAFT
SUB–ASSY
(a) Loosen the bolt and remove the clamp from the steering
column hole cover No.1.
(b) Disconnect the steering column hole cover No.2 from the
steering column hole cover No.1.
(c) Loosen the bolt.
(d) Place matchmarks on the steering intermediate shaft
sub–assy and rack & pinion power steering gear assy.
(e) Remove the bolt and separate the steering intermediate
shaft sub–assy.
To Next Page
Loading...
Need help?
General
