3006H–01
F40167
C83023
–DRIVE SHAFT / PROPELLER SHAFT FRONT AXLE HUB SUB–ASSY LH
30–21
1975Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
FRONT AXLE HUB SUB–ASSY LH
REPLACEMENT
HINT:
COMPONENTS: See page 30–4
Replace the RH side by the same procedures with LH side.
1. REMOVE FRONT WHEEL
2. REMOVE FRONT AXLE HUB LH NUT
(See page 30–8)
SST 09930–00010
3. DISCONNECT SPEED SENSOR FRONT LH(W/ ABS)
(See page 30–8)
4. DISCONNECT FRONT DISC BRAKE CALIPER ASSY
LH
(a) Remove the 2 bolts, disconnect the front disc brake cali-
per assy LH from the steering knuckle LH.
5. REMOVE FRONT DISC
6. DISCONNECT TIE ROD ASSY LH
(See page 30–8)
SST 09628–62011
7. DISCONNECT FRONT SUSPENSION ARM SUB–ASSY LOWER NO.1 LH
(See page 30–8)
8. REMOVE FRONT AXLE ASSY LH
(a) Using a plastic hammer, separate the front drive shaft
assy LH from the front axle hub sub–assy LH.
NOTICE:
w/ ABS:
Be careful not to damage the boot and ABS speed sensor
rotor.
(b) Remove the 2 bolts, nuts and steering knuckle LH with the
front axle hub sub–assy LH.
9. REMOVE LOWER BALL JOINT ASSY FRONT LH
(a) Remove the cotter pin and nut.
To Next Page
Loading...
Need help?
General
