Z11554
Seal Lock Adhesive
BE1367
Medium Current Fuse and High Current
Fuse Equal Amperage Rating
D27353
V35001
Illustration
Symbol Part Name
Abbreviation
FUSE
MEDIUM CURRENT FUSE
HIGH CURRENT FUSE
FUSE
M–FUSE
H–FUSE
01–6
–INTRODUCTION REPAIR INSTRUCTION
6Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
(c) PRECOATED PARTS
(1) Precoated parts are bolts, nuts, etc. that are coated
with a seal lock adhesive at the factory.
(2) If a precoated part is retightened, loosened or
caused to move in any way, it must be recoated with
the specified adhesive.
(3) When reusing precoated parts, clean off the old
adhesive and dry the part with compressed air.
Then apply the specified seal lock adhesive to the
bolt, nut or threads.
NOTICE:
Perform the torque checking with the lower limit value of
the torque tolerance.
(4) Depending on the seal lock agent to apply, there
may be a case where it is necessary to leave it for
a specified time until it hardens.
(d) GASKETS
(1) When necessary, use a sealer on gaskets to prevent leaks.
(e) BOLTS, NUTS AND SCREWS
(1) Carefully observe all the specifications for tightening torques. Always use a torque wrench.
(f) FUSES
(1) When replacing fuses, be sure that a new fuse has
the correct amperage rating. DO NOT exceed the
rating, or use one with a lower rating.
To Next Page
Loading...
Need help?
General
