Toyota 2002 Camry User Manual

320CX–01
F41697
Stop Lamp
Switch Assy
Push Rod
Pedal Height
Normal type:
F41699
Link type:
Stop Lamp Switch Assy
Push Rod
Pedal
Height
32–6
–BRAKE BRAKE PEDAL SUPPORT ASSY
1994Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
BRAKE PEDAL SUPPORT ASSY
ADJUSTMENT
1. CHECK AND ADJUST BRAKE PEDAL HEIGHT
(a) Inspect brake pedal height.
Pedal height from asphalt sheet:
144.1 – 154.1 mm (5.673 – 6.067 in.)
(b) Adjust brake pedal height.
(1) Remove the instrument panel finish panel sub–
assy lower and instrument panel insert sub–assy
lower LH.
(2) Disconnect the connector from the stop lamp switch
assy.
(3) Loosen the stop lamp switch lock nut and remove
the stop lamp switch assy.
(4) Loosen the clevis lock nut.
(5) Adjust the pedal height by turning the pedal push
rod.
(6) Tighten the push rod lock nut.
Torque: 26 N⋅m (265 kgf⋅cm, 19 ft⋅lbf)
(7) Install the stop lamp switch assy.
(8) Connect the connector to the stop lamp switch assy.
(9) Push the brake pedal in 5 – 10 mm (0.20 – 0.39 in.),
turn the stop lamp switch assy to lock the nut in the
position where the stop lamp goes off.
(10) After installation, push the brake pedal in 5 – 10 mm
(0.20 – 0.39 in.), check that stop lamp lights up.
(11) TMMK made:
Install the .
(12) Install the instrument panel insert sub–assy lower
LH and instrument panel finish panel sub–assy low-
er.

Toyota 2002 Camry Specifications

General

Brand	Toyota
Model	2002 Camry
Category	Automobile
Language	English