1101Q–02
Pulsation Damper
A51983
A62372
O–ring
Grommet
Insulator
–FUEL FUEL INJECTOR ASSY (1MZ–FE)
11–35
1479Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
REPLACEMENT
1. WORK FOR PREVENTING GASOLINE FROM SPILLING OUT (See page 11–26)
2. DRAIN COOLANT (See page 16–20)
3. REMOVE V–BANK COVER SUB–ASSY
(See page 14–155)
4. REMOVE BATTERY
5. REMOVE AIR CLEANER ASSEMBLY WITH HOSE (See page 10–12)
6. REMOVE FRONT SUSPENSION UPPER BRACE CENTER
(W/ FRONT SUSPENSION BRACE UPPER CENTER)
7. REMOVE INTAKE AIR SURGE TANK
(See page 14–142)
8. SEPARATE FUEL PIPE SUB–ASSY NO.1
(a) Remove the pulsation damper and 2 gaskets.
(b) Remove the bolt and 2 gaskets.
(c) Remove the bolt and disconnect the fuel pipe sub–as-
sembly No. 1 from the intake manifold.
9. REMOVE FUEL INJECTOR ASSY
(a) Disconnect the injector connectors.
(b) Remove the 2 bolts and fuel delivery pipe, while pulling out both ends of the fuel delivery pipe equally.
(c) While turning the injector clockwise and counterclockwise, pull out the injector from the delivery pipe.
10. INSTALL FUEL INJECTOR ASSY
(a) Apply a light coat of gasoline to a new O–ring and install
them to each injectors.
(b) While turning the injector clockwise and counterclock-
wise, install it to the delivery pipe.
(c) Check that the injectors rotate smoothly.
NOTICE:
If injectors do not rotate smoothly, the probable cause is in-
correct installation of the O–rings. Replace new O–rings.
(d) Install the delivery pipe with the injectors.
Torque: 10 N⋅m (102 kgf⋅cm, 7 ft⋅lbf)
NOTICE:
Be careful not to drop the injectors when installing
the delivery pipe.
Check that the injectors rotate smoothly after instal-
ling the delivery pipe.
To Next Page
Loading...
Need help?
General
