5105O–01
F40529
F40342
SST
AB
F41481
SST
51–8
–POWER STEERING VANE PUMP ASSY (2AZ–FE)
2275Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
OVERHAUL
NOTICE:
When using a vise, do not over tighten.
When installing, coat the parts indicated by the arrows with power steering fluid
(See page 51–7).
1. REMOVE FRONT WHEEL RH
2. DRAIN POWER STEERING FLUID
3. REMOVE FRONT FENDER LINER RH
4. REMOVE FRONT FENDER APRON SEAL RH
5. REMOVE FAN AND GENERATOR V BELT
(See page 14–5)
SST 09249–63010
6. DISCONNECT OIL RESERVOIR TO PUMP HOSE NO.1
(a) Remove the clip and disconnect the oil reservoir to pump hose No.1.
NOTICE:
Take care not to spill fluid on the V belt.
7. DISCONNECT PRESSURE FEED TUBE ASSY
(a) Disconnect the connector from the power steering oil
pressure switch.
(b) Using a spanner (27 mm) to hold the pressure port union,
remove the union bolt and gasket.
8. REMOVE VANE PUMP ASSY
(a) Disconnect the connector from the oil pressure switch.
(b) Using SST and a deep socket (14 mm), loosen the bolt A.
SST 09249–63010
(c) Remove the bolt B and vane pump assy.
9. FIX VANE PUMP ASSY
(a) Using SST, hold the vane pump assy on the vise through
the aluminum plate.
SST 09630–00014 (09631–00132)
HINT:
As follow the necessity, remove and install SST for holding.
To Next Page
Loading...
Need help?
General
