2605T–01
C91608
B
Front:
A
C91609
C
Rear:
D
SA3213
A
D
B
Front
C
–FRONT SUSPENSION FRONT WHEEL ALIGNMENT
26–5
1917Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
FRONT WHEEL ALIGNMENT
ADJUSTMENT
1. INSPECT TIRE(See page 28–1)
2. MEASURE VEHICLE HEIGHT
Vehicle height:
1MZ–FE COMFORT:
Front (A – B) 120 mm (4.72 in.)
Rear (D – C) 46 mm (1.81 in.)
1MZ–FE PREMIUM:
USA, Canada Mexico
Front (A – B) 119 mm (4.69 in.) 106 mm (4.17 in.)
Rear (D – C) 47 mm (1.85 in.) 33 mm (1.30 in.)
1MZ–FE SPORT:
Front (A – B) 120 mm (4.72 in.)
Rear (D – C) 48 mm (1.89 in.)
2AZ–FE COMFORT:
USA, Canada Mexico
Front (A – B) 119 mm (4.69 in.) 106 mm (4.17 in.)
Rear (D – C) 45 mm (1.77 in.) 33 mm (1.30 in.)
2AZ–FE PREMIUM:
Front (A – B) 120 mm (4.72 in.)
Rear (D – C) 45 mm (1.77 in.)
2AZ–FE SPORT:
Front (A – B) 120 mm (4.72 in.)
Rear (D – C) 48 mm (1.89 in.)
Measuring points:
A: Ground clearance of front wheel center
B: Ground clearance of lower suspension arm No. 2 set bolt
center
C: Ground clearance of strut rod set bolt center
D: Ground clearance of rear wheel center
NOTICE:
Before inspecting the wheel alignment, adjust the vehicle
height to the specified value.
If the vehicle height is not the specified value, try to adjust it by
pushing down on or lifting the body.
3. INSPECT TOE–IN
Toe–in:
Toe–in
(total)
A + B: 0° ± 12’ (0° ± 0.2°)
C – D: 0 ± 2 mm (0 ± 0.08 in.)
If the toe–in is not within the specified value, adjust it at the rack
ends.
4. ADJUST TOE–IN
(a) Remove the rack boot set clips.
(b) Loosen the tie rod end lock nuts.
To Next Page
Loading...
Need help?
General
