1404R–02
CG
TC
A51075
A52004
–ENGINE MECHANICAL ENGINE ASSEMBLY (2AZ–FE)
14–1
1523Author: Date:
2002 CAMRY REPAIR MANUAL (RM881U)
ENGINE ASSEMBLY (2AZ–FE)
INSPECTION
1. INSPECT COOLANT (See page 16–20)
2. INSPECT ENGINE OIL
3. INSPECT BATTERY
Standard specific gravity: 1.25
– 1.29 at 20C (68F)
4. INSPECT AIR CLEANER FILTER ELEMENT SUB–ASSY
5. INSPECT SPARK PLUG
(See page 18–1)
6. INSPECT V–RIBBED BELT
7. INSPECT IGNITION TIMING
(a) Warm up engine.
(b) When using hand–held tester.
(1) Connect the hand–held tester to the DLC3.
Ignition timing: 8 – 12 BTDC
HINT:
Please refer to the hand–held tester operator’s manual for fur-
ther details.
(c) When not using hand–held tester.
(1) Using SST, connect terminals 13 (TC) and 4 (CG)
of DLC3.
SST 09843–18040
NOTICE:
Be sure not to connect incorrectly. It causes breakage
of the engine.
Turn OFF all electrical systems.
Operate the inspection when the cooling fan motor is
turned OFF.
(2) Remove the cylinder head cover No.2.
(3) Pull out the wire harness as shown in the illustration.
Connect the clip of the timing light to the engine.
NOTICE:
Use a timing light which can detect the first signal.
After checking, be sure to tape the wire harness.
(4) Inspect ignition timing at idle.
Ignition timing: 8 – 12 BTDC
NOTICE:
When checking the ignition timing, the transmission is at
neutral position.
HINT:
After engine rpm is kept at 1,000 – 1,300 r/min. for 5 seconds,
check that it returns idle speed.
To Next Page
Loading...
Need help?
General
