Location
Indicates the port to which the USB drive is connected.
Site
Indicates the folder you created on the USB drive to which the back up system file is saved.
System
The back up file named with the IP address of the control board from which it was saved.
10.3 Managing Access Permission and Passwords
NOTICE
Risk of loss of access to Vertiv™ Liebert® iCOM™ can cause operational problems.
When a password is changed, make sure you record the new password and inform authorized users. If problems
arise, passwords can be reset by Vertiv Technical Support, visit https://www.vertiv.com/en-us/support/.
Two four digit passwords provide two levels of permission to access Liebert® iCOM™ menus and are set with factory-default
values. You can change the value of each password so that only those provided with the current password may access the
menus that it unlocks.
The factory-default password for user and service login are:
• Default User password: 1490
• Default Service password: 5010
NOTE: To change the password, you must use the Service password currently assigned to unlock the Service menu.
1. Touch , then > Backup & Security > Manage Permissions.
The MANAGE PINS panel opens.
2. Touch the role to change, then touch the Value field for the password to change. The keypad opens.
3. Type a new four digit/character password, then touch , and touch Save. The password is saved.
• Touch Cancel to discard the change.
10 Administering Firmware, Settings and Security
164
Vertiv™ Liebert® iCOM™Installer/User Guide
To Next Page
Loading...
Need help?
General
