1.4 Battery terminal connection
Caution
To prevent damage to the battery terminal clamps and battery
terminals, the following should be observed:
♦ The battery terminal clamps should only be fitted by hand
and without using force.
♦ Battery terminals should not be coated with grease.
♦ The battery terminal clamps should be fitted so that the
battery terminal is either flush with the clamp or protruding
from it.
♦ Once the battery terminal clamps have been tightened to
the specified torque, the threaded connections should not
be tightened any further.
The tightening torque for the battery terminal clamps -1- and the
additional clamps-2- can be found in this table “Tightening tor‐
ques: Battery” ⇒ page 36 .
Jetta 2005 ➤ , Bora 2006 ➤
Electrical System - Edition 05.2005
4 Rep. Gr.27 - Starter, current supply, CC