When the ignition is switched on, the electronic immobilizer de‐
tects a valid vehicle key and deactivates the anti-theft alarm
system.
10.2 Removing and installing anti-theft alarm
ultrasonic sensor -G209-
The anti-theft alarm ultrasonic sensor -G209- , comprising 4 indi‐
vidual sensors -2-, leads and a control element on the back of the
interior and reading light, cannot be replaced individually, the en‐
tire rear interior and reading light must be replaced.
– Removing and installing rear interior and reading light (vehi‐
cles with ATAS) ⇒ page 268 .
10.3 Removing and installing vehicle inclina‐
tion sender -G384-
The vehicle inclination sender -G384- -arrow- is located under the
dash panel right behind the front passenger airbag.
Note
The anti-theft alarm system must be deactivated before the send‐
er is removed ⇒ page 277 .
Removing:
– Switch off ignition and all electrical consumers and pull out
ignition key.
– Remove glove compartment ⇒ General body repairs, interior;
Rep. Gr. 68 ; Compartments, covers and trim; Removing and
installing glove compartment; Removing .
– Unscrew the securing bolts -1- and remove vehicle inclination
sender -G384- from the bracket.
– Release the connector -2- and pull it away from the vehicle
inclination sender -G384- .
Installing:
Install in reverse order of removal.
10.4 Central locking and anti-theft alarm sys‐
tem aerial -R47-
Note
Additional information:
Jetta 2005 ➤ , Bora 2006 ➤
Electrical System - Edition 05.2005
278 Rep. Gr.96 - Lights, lamps, switches - inside