Driver's side:
Distance -A- between wiper blade and upper edge of plenum
chamber cover should be 10 mm.
– If necessary, adjust wiper blade park position by moving wiper
arm.
Removing wiper arms ⇒ page 158 .
– Tighten threaded connection to specified torque setting
⇒ page 178 .
Front passenger's side:
Distance -B- between wiper blade and upper edge of plenum
chamber cover should be 10 mm.
– If necessary, adjust wiper blade park position by moving wiper
arm.
Removing wiper arms ⇒ page 158 .
– Tighten threaded connection to specified torque setting
⇒ page 178 .
1.5 Removing and installing aerodynamic
wipers
Removing:
Note
♦
Driver's and front passenger wiper blades should not be inter‐
changed during installation.
♦
The aerodynamic wipers are very flexible. To lift the wiper
blades off the windscreen, touch them only in the area in which
the wiper blades are attached to the wipers.
♦
To remove the wiper blades, the wiper arms should be placed
in the “service/winter position”. The“service/winter position” is
activated within 10 seconds after ignition is switched off by
pressing windscreen wiper lever in “tip wipe”.
– Place wiper arm in “service/winter position” by operating the
windscreen wiper lever within 10 seconds after ignition is
switched off in “tip wipe” position.
– Lift up wiper arm.
Jetta 2005 ➤ , Bora 2006 ➤
Electrical System - Edition 05.2005
162 Rep. Gr.92 - Windscreen wash/wipe system