8 Additional brake light
8.1 Removing and installing high level brake
light bulb -M25-
Note
In the event of damage, the complete high level brake light -M25-
unit must be renewed.
Removing:
– Switch off ignition and all electrical consumers and pull out
ignition key.
– Remove strip roof leading edge ⇒ General body repairs, in‐
terior; Rep. Gr. 70 ; Removing and installing strip roof leading
edge .
– Pull connector -1- off.
– Press high level brake light bulb -M25- to rear window
-in direction of arrow-
Installing:
Installation is performed in the reverse order of installation; when
doing this, note the following:
Jetta 2005 ➤ , Bora 2006 ➤
Electrical System - Edition 05.2005
218 Rep. Gr.94 - Lights, lamps, switches - outside