– Unlock locking tabs -1- and take thermal protection plate -2-
off the lens or the light.
– Lever bulb carefully out of the holder.
– Renew glas base bulb (12 V, 5 W).
Installing:
Installation is carried out in the reverse order. When installing,
note the following:
– Check functions of glove box switch. The lamp must not light
when the lid is closed.
2.3 Removing and installing glove compart‐
ment light switch -E26-
The glove compartment light switch can be found on the rear of
the glove compartment.
Removing:
– Switch off the ignition and all electrical consumers.
– Remove glove compartment ⇒ General body repairs, interior;
Rep. Gr. 68 ; Compartments, covers and trim; Removing and
installing glove compartment .
– Unlock locking lug -1- and slide the switch out of the guide
-arrow-.
Installing:
Install in reverse order of removal.
2.4 Removing and installing switches and
instruments illumination regulator -E20-
Removing:
– Switch off the ignition and all electrical consumers.
– Remove light switch ⇒ page 240 .
– Remove stowage compartment on driver side ⇒ General body
repairs, interior; Rep. Gr. 68 ; Compartments, covers and trim .
Jetta 2005 ➤ , Bora 2006 ➤
Electrical System - Edition 05.2005
242 Rep. Gr.96 - Lights, lamps, switches - inside