Wintriss wpc 2000 User Manual

Index I-1
Index
–A–
AC power
specifications
,1-8
wiring,2-8
air pressure switch, installing and wiring,2-11
American National Standards Institute (ANSI)
extracts of standards
,A-5
safety distance formula,3-21
anti-repeat test,3-49
anti-tiedown test,3-48
auto carry-up angle
enabling changes to
,3-29
setting,3-13
Auto Compensated Top Stop (ACTS),
enabling
,3-28
automatic continuous on-demand mode
operating the press
,4-19
setting prior act time,3-29
wiring,2-48
automatic single-stroke mode
operating the press
,4-16
setting prior act time,3-29
wiring,2-48
auxiliary equipment, faults,5-12
auxiliary outputs
change conditions
,2-31
setting aux. output 1 response to interrupted
stroke
,3-31
wiring,2-30
–B–
bar mode
fault
,5-10
mounting and wiring the control,2-47
operating the press in,4-19
testing the control,3-57
brake monitor
calculating the stop-time limit
,3-15
calculating the Tbm value,3-15
displaying the 90° stop time,3-17
displaying the stopping time,3-14
faults,5-3
location of brake warning LED,1-5
responding to brake warning LED,4-3, 5-3
responding to stop time exceeded message,5-4
setting the stop-time limit,3-16
using Tbm setting in ANSI safety distance
formula
,3-21
brake warning LED, responding to,4-3, 5-3
–C–
cable, display. See display cable
cam
enabling changes to cam settings
,2-40
mounting and wiring cam output assembly,2-36
setting cam channel timing,3-33
wiring cam relays,2-38
wiring zero cam output to AutoSet,2-42
clutch air pressure switch. See air pressure switch
concurrent time, setting for multiple op.
stations
,3-33
continuous mode
operating the press in automatic continuous
on-demand
,4-19
operating the press in continuous foot,4-18
operating the press in continuous two-hand,4-17
testing with light curtain(s),3-50
testing without light curtain(s),3-52
control enclosure. See enclosure (WPC 2000)
controls (Wintriss), connecting to WPC 2000
,2-33
counter
disabling counter preset
,4-7
resetting counter preset to 999999,4-8
resetting counter preset to zero,4-7
resetting counter to zero,4-6
viewing and setting counter preset,4-6
viewing counter,4-5
counterbalance air pressure switch. See air pressure
switch
cross-checked inputs. See user inputs
cutout dimensions. See dimensions (mounting/
cutout)
–D–
DC power requirements,1-8
dead motor inch, operating the press in,4-10
dimensions (mounting/cutout)
cam output assembly
,2-37
cam output board,2-37
one-hand control switch, 2-44, 2-45
pre-wired operator station,2-15
resolver,2-21
selector switches,2-55
unwired operator station,2-16
WPC 2000 display board kit,2-56
WPC 2000 enclosure,2-7
WPC 2000 mounting plate,2-52
WPC 2000 panel mount,2-53
diode, installing across a DC load,2-40
display (WPC 2000), components,1-4
display board kit (WPC 2000), installing,2-55
display cable, connecting correctly to display
board
, 2-54, 2-57

Wintriss wpc 2000 Specifications

General

Brand	Wintriss
Model	wpc 2000
Category	Controller
Language	English