Imaging Preferences 6 - 13
Image Brightness (Target White)
Parameter # 390 (SSI # F0h 86h)
Type: Byte
Range: 1 - 240
This parameter sets the Target White value used in Snapshot mode when using auto exposure. White and black
are defined as 240 decimal and 1, respectively. Setting the value to the factory default of 180 sets the white level of
the image to ~180.
To set the Image Brightness parameter, scan Image Brightness below followed by three numeric bar codes
representing the value. Leading zeros are required. For example, to set an Image Brightness value of 99, scan 0,
9, 9. See Appendix G, Numeric Bar Codes for numeric bar codes.
JPEG Image Options
Parameter # 299 (SSI # F0h 2Bh)
Select an option to optimize JPEG images for either size or for quality. Scan the JPEG Quality Selector bar code
to enter a quality value; the digital scanner then selects the corresponding image size. Scan the JPEG Size
Selector bar code to enter a size value; the digital scanner then selects the best image quality.
*180
Image Brightness
(3 digits)
*JPEG Quality Selector
(1)
JPEG Size Selector
(0)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
