Driver’s License Set Up (DS8178-DL) 16 - 3
Parsing Driver’s License Data Fields
(Embedded Driver's License Parsing)
To begin programming a parsing rule:
1. Scan Begin New Driver’s License Parse Rule on page 16-4.
2. Scan any of the field bar codes on the following pages, or Send Keystroke (Control Characters and Keyboard
Characters) on page 16-20 to complete the parsing rule.
3. After entering the entire rule, scan Save Driver’s License Parse Rule on page 16-4 to save the rule.
To abort the programming sequence at any time during programming, scan Quit Entering Driver’s License Rule on
page 16-4. Any previously saved rule is retained.
To erase a programmed saved rule, scan Erase Driver’s License Parse Rules on page 16-4.
Embedded Driver's License Parsing Criteria - Code Type
After specifying the fields and their order for the parsed driver's license, you can also apply standard ADF rules to
the parsed data using the
Parsed Driver’s License criterion bar code in the Advanced Data Formatting Programmer
Guide.
See Embedded Driver's License Parsing ADF Example on page 16-45 for a sample ADF rule using this code type
criterion.
NOTE Only ONE driver’s license parsing rule may be stored in memory at any time. Saving a new rule replaces
the prior rule.
NOTE Only create standard ADF rules on parsed driver's license data when configured for Embedded Driver's
License Parsing.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
