Zebra ZD410 User Manual

152
Interface Connector
Wiring
Universal Serial Bus (USB) Interface
The figure below displays the cable wiring required to use the printer’s USB two interfaces.
Important • When using third party cables, the printer requires USB cables or the cable packaging that bears the
“Certified USB ™ ” mark to guarantee USB 2.0 compliance.
Wiring - USB Connector “A” Style for “connecting to” the printer or device
Pin 1 — Vbus (+5VDC). (Pin 2 — D- (Data Signal, Negative Side)
Pin 3 — D+ (Data Signal, Positive Side)
Pin 4 — Shell (Shield/Drain Wire) Shell
Wiring - USB Connector “B” Style for “connecting to” the printer or device
Pin 1 — Vbus (Not Connected)
Pin 2 — D- (Data Signal, Negative Side)
Pin 3 — D+ (Data Signal, Positive Side)
Pin 4 — Shell (Shield/Drain Wire) Shell
Important • USB Host +5 VDC power source is shared with serial port phantom power. It is limited to 0.5mA per USB
Specification and with on-board current limiting. The maximum current available through the serial port and USB port
will not exceed a total of 0.75 Amps.






http://www.usb.org
A
B

Zebra ZD410 Specifications

General

Wi-Fi	Yes
Ethernet LAN	No
Wi-Fi standards	Wi-Fi 5 (802.11ac)
Bluetooth version	4.1
USB 2.0 ports quantity	1
Connectivity technology	Wired & Wireless
Print technology	Direct thermal
Maximum resolution	300 x 300 DPI
Maximum print height	991 mm
Maximum printing width	56 mm
Flash memory	512 MB
Internal memory	256 MB
Built-in barcodes	1D, 2D
Page description languages	EPL, EPL2, XML, ZPL, ZPL II
Display	-
Product color	Gray
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Sustainability certificates	ENERGY STAR
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	5 - 41 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	10 - 90 %
Core diameter	12.7 mm
Media thickness	0.08 - 0.305 mm
Maximum roll diameter	127 mm
Harmonized System (HS) code	84433210

Weight and Dimensions

Depth	220 mm
Width	115 mm
Height	151 mm
Weight	1000 g