Zebra ZD410 User Manual

Introduction
25
Battery Indicators and Controls
The optional printer battery accessory has a simple, one button, 4 LED indicator light user interface to
control and display battery status and health. The battery acts as a UPS (uninterruptible power supply) for
the printer. For more information on using the battery with your printer and power saving modes (Sleep,
Shutdown, etc.), see Printing with the Attached Battery Base and Battery Option.
Battery Control Button — The button helps you control the battery, both inside and outside of the printer.
• Battery On - Press and release
• Wakes up (activates power) the battery from Sleep or Shutdown Modes. The battery health
and charge status are checked. The battery indicators all flash on and off together 3 times. The
operator now has one (1) minute to turn the printer on before the battery reverts back to the
previous Sleep or Shutdown Mode.
• Battery displays the battery level charge during the first ten (10) seconds after internal
battery health checks are complete
• Shutdown Mode - Press and hold the button for 10-11 seconds and release. The battery begins
shutdown and approximately 3 seconds later all of the battery LEDs will flash three (3) times to let
you know the battery has shut down.
Battery Health Indicator — Displays the battery’s charging status and health of the battery.
• Green - Good health, charge complete and ready to operate.
• Amber - Charging (printer is OFF).
• Red - Battery has an internal error. Remove the battery and see the Troubleshooting.
• Flashing Red - Charging error - over or under temperature, internal monitoring error, etc.
Battery Charge Level Indicator — Displays the battery’s charging status and health of the battery.
• Three (3) green bars on, no flashing - Battery is fully charged. (The battery will not start charging
• Two (2) green bars on with the top bar flashing. Less than full charge.
• One (1) green bar flash - Time to charge your battery!
• No bars on - Battery needs charging, but the Battery Health Indicator flashes when the Battery
Control Button is pressed. The printer can not be turned on.
• Amber - Charging.
Rear of Battery
Battery Control
Button
Health Indicator
Charge Level Indicators (3)
Charge Level
Indicators (3)
Health Indicator

Zebra ZD410 Specifications

General

Wi-Fi	Yes
Ethernet LAN	No
Wi-Fi standards	Wi-Fi 5 (802.11ac)
Bluetooth version	4.1
USB 2.0 ports quantity	1
Connectivity technology	Wired & Wireless
Print technology	Direct thermal
Maximum resolution	300 x 300 DPI
Maximum print height	991 mm
Maximum printing width	56 mm
Flash memory	512 MB
Internal memory	256 MB
Built-in barcodes	1D, 2D
Page description languages	EPL, EPL2, XML, ZPL, ZPL II
Display	-
Product color	Gray
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Sustainability certificates	ENERGY STAR
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	5 - 41 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	10 - 90 %
Core diameter	12.7 mm
Media thickness	0.08 - 0.305 mm
Maximum roll diameter	127 mm
Harmonized System (HS) code	84433210

Weight and Dimensions

Depth	220 mm
Width	115 mm
Height	151 mm
Weight	1000 g