6、COOLING SYSTEM COMPONENT
54
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1224300-030000 ZT350-V vice water tank 1
PROCEDURE:
●Add coolant
When the engine is completely cooled, the vehicle can be straightened to accurately check the liquid level. If
it is lower than the "L" line, the coolant should be replenished in time. If the auxiliary tank has no or only a
small amount of coolant, check the cooling system first, and remove the leak before adding it.
Park the vehicle with the side brackets; turn the direction to the right and turn to the bottom.
Open the lid of the sub tank ⑴ and add a small amount of coolant each time with a funnel. It is appropriate
to reach the position of the F line when the liquid level of the coolant is used to support the vehicle.
CAUTION:
●Check regularly the cooling liquid surface. It should never be lower than "L" line.
●Change cooling liquid every two years is suggested.
●Swallowing or inhaling cooling liquid would harm human body. Clean thoroughly the hands, face or
explosing skin every time after adding cooling liquid. If cooling liquid is swalled by accident, please contact
toxication center or hosipital. If it's inhaled, please move to open air. If it's spilt to the eye, clean it with big
quantity of clean water and see doctor in time. Be sure the cooling liquid is far away from children or pets.
●Engine cooling liquid must be suitable for aluminum radiator. The basic should be glycol. Cooling liquid
should be mixture of distilled water and concentrated cooling liquid under certain proportion. Be sure to
choose cooling liquid which is suitable for your local extreamly low temperature. The freezing point should be
lower than the local lowest temperature. Distilled water is the only kind of water acceptable. Other kind of
water might cause corrosion to engine cooling system or other more severe problems.
●Total volume of cooling liquid is 1580ml.
●Cooling liquid might damage the coating of motorcycle. Be careful while adding. If it is spilt in small
quantity, please clean it immediately with soft cloth.
Fig.3 COOLING SYSTEM
COMPONENT
Add coolant
To Next Page
Loading...
Need help?
General
