7、FRONT FORK COMPONENT
62
CHK
ADJ
Fig.2 FRONT FORK
COMPONENT
Light height adjustment
PROCEDURE:
●Light height adjustment
The driver sits in the bike and straightens the bike. The other person inserts the PH2 type Phillips screwdriver
(diameter 6mm) into the hole at the bottom of the vehicle head, aligns it with the tooth profile of the
adjusting bolt, turns clockwise for lowering, and counterclockwise for higher beam height.
CAUTION:
●Light height adjustment should be noted as follows:
Too High or too low light levels can affect safe driving. The height of the lights should be properly adjusted
according to whether there are changes in the weight of the occupants and the driver.
It is forbidden to adjust the light height during riding. It is advisable to adjust the road with a smooth road
surface and a straight line distance of about 150 meters without affecting traffic safety at night.
To Next Page
Loading...
Need help?
General
