Menu tree REC 561
ABB Network Partner AB
1MRK 580 189-XEN
Page 3 - 39
Version 1.0-00
3.1 Mean values Mean values of the measured current, voltage, active and reactive power,
and of the frequency, are displayed on the control terminals.
3.2 Phasors The control terminal displays primary and secondary phasors of measured
currents and voltages.
3.3 Synchronizing values The actual measured values of phase angle, voltage, and frequency differ-
ences are displayed if the optional synchro-check is built into the control
terminal.
3.4 Logical signals The current values of internal logical signals are displayed on the Logical
signals submenu.
3.5 I/O modules For each of the included I/O modules, the current logical values of all
binary inputs and outputs of a terminal and the analogue values of the mA
input module are always displayed.
3.6 Counters within the
autoreclosing function
Autoreclosing functions are available as options. They also comprise dif-
ferent counters, and their actual values are displayed on this submenu.
You can reset the counters to the initial zero value on this submenu.
3.7 Disturbance report The service report information on the disturbance report contains:
• Percentage of the used dedicated memory capacity for purposes of
the disturbance recording function, when it is built into the terminal.
• The sequence number that the next recorded disturbance receives
(can be both read and set here).
• The status of built-in analogue triggers that can start operation of the
disturbance recorder.
3.8 Active group The current active setting group is displayed on this submenu.
3.9 Internal time You can check he internal terminal time on this submenu. The data con-
tains information about the date and the time - down to seconds.
To Next Page
Loading...
Need help?
General
