3 DC Power Supply Operation
Sweep Functions
96 U3606A User’s and Service Guide
Generating a scan signal
1 Select your desired output mode by pressing Voltage to enable constant
voltage operation or Current to enable constant current operation. (The
respective annunciator — CV or CC — will illuminate accordingly.)
2 Select an appropriate range by pressing Shift > Range. The maximum
amplitude end position will be limited by the range selected. (The
respective annunciator — S1 or S2 —will illuminate accordingly.)
3 If you want to fine- tune the scan signal parameters, press Shift > Utility
to access the utility menu. See “Configuring the scan signal
parameters” on page 124 for more information on configuring the ramp
signal parameters. Press Shift > Save to save the changes and Shift > Exit
to exit the utility menu.
4 Press Ramp Scan to select the scan function. Ensure that the Scan
annunciator is shown on the display.
5 Press to generate the scan signal.
To Next Page
Loading...
Need help?
General
