2 Digital Multimeter Operation
Math Operations
62 U3606A User’s and Service Guide
MinMax
The MinMax operation stores the minimum and maximum values, the
average, and the number of readings during a series of measurements.
From the front panel, you can view the following statistical data for any
set of readings: average or mean (Avg), maximum (Max), and minimum
(Min).
Enabling the MinMax operation
Press MinMax to enable the MinMax operation.
The Max annunciator is illuminated and the U3606A begins accumulating
various statistics about the readings being displayed.
Press MinMax again to step through the maximum reading (the Max
annunciator is illuminated), minimum reading (the Min annunciator is
illuminated), average reading (the Avg annunciator is illuminated), or
present reading (the MaxMinAvg annunciator is illuminated).
• This math operation applies to all measurement functions except
continuity and diode test.
• The stored statistical data are cleared when statistics are enabled,
when the
CALculate:FUNCtion command is sent while the
CALCulate:STATe is ON, when the power is turned off, after a
Factory Reset (
*RST command), after an Instrument Preset
(
SYSTem:PRESet command), or after a measurement function
change.
To Next Page
Loading...
Need help?
General
