Installing the flywheel
•
Position the flywheel on the crankshaft.
•
Block flywheel rotation using the spe-
cific tool.
•
Tighten the screw.
Specific tooling
020914Y Flywheel retainer
Flywheel cover installation
•
Insert the centring dowels in the cover.
•
Apply a layer of sealing paste along the
external edge of the cover.
•
Insert the cover together with the sta-
tor.
Recommended products
Three bond Sealing paste
-
•
Tighten the five screws (1) and the
three special screws (2).
•
Tighten the screws working in stages
and diagonally.
•
Insert the Blow-by system pipe and
fasten it with a new clamp.
•
Position the soundproofing cover and lock it in place using the three appropriate screws
Engine RSV4 RR-RF
ENG - 290
To Next Page
Loading...
Need help?
General
