•
Remove the pumping member pin.
Checking the components
(PROCEDURE FOR OHLINS FORKS)
Stem
Check that the sliding surface is not scratched or scored.
Any scoring can be removed by sanding with damp sandpaper (grain 1).
If the scratches are deep, replace the stem.
Using a dial gauge, check than any bending of the stem is below the limit value.
If it is over the limit, replace the stem.
CAUTION
A BENT STEM SHOULD NEVER BE STRAIGHTENED SINCE ITS STRUCTURE WOULD BE WEAK-
ENED MAKING THE VEHICLE DANGEROUS TO USE.
Characteristic
Bending limit:
0.2 mm (0.00787 in)
Sleeve
Check for damage and/or cracks; if it is damaged, replace it.
Springs
Check the condition of the springs, making sure that the length is within the acceptable limits.
If not, replace the springs.
MINIMUM LENGTH OF FREE SPRING: 260 mm (10.24 in)
(PROCEDURE FOR SACHS FORKS)
Stem
Check that the sliding surface is not scratched or scored.
Any scoring can be removed by sanding with damp sandpaper (grain 1).
If the scratches are deep, replace the stem.
Using a dial gauge, check than any bending of the stem is below the limit value.
If it is over the limit, replace the stem.
CAUTION
RSV4 RR-RF Suspensions
SUSP - 407
To Next Page
Loading...
Need help?
General
