15. Removal and installation of the projector covers
15.7 Installation of the side cover plate of the Light Processor compartment
Necessary tools
3mm Allen wr ench.
How to install the side cover plate from the Light Processor compartment?
1. Place the s ide c over plate into position as illustrated. Ensure that all 1 2 s lots of the side cover plate are engaged (three at eac h
side).
2
1
C
B
B
A
C
Image 15-9
2. Fasten the side cover plate with a screw a
t the top (reference 1 image 15-9) and the two screws at the bottom (reference 2
image 15-9). Use a 3m m Allen wrench.
CAUTION: O pening the Light Processor com partm ent by removing the top c over p late or side cover plate will
result in a tamper event. An authorization to clear the security w arning on the projector, after clo sing off the
Light Processor co mp artment, will be needed !
R5906847 DP2K SLP SERIES 02/06/2017 139
To Next Page
Loading...
Need help?
General
