MY23P0a -52_1.0_11.10.2022
139
Operation
6.5.6 Stem
6.5.6.1 Replacing the handlebars
Not included in price
6.5.6.2 Adjusting the handlebar height with
quick release
Only applies to pedelecs with this equipment
1 Open the stem clamping lever.
Figure 120: Open (2) and closed (1) stem clamping lever;
All Up used as an example
2 Pull out the handlebars to the required height.
Observe minimum insertion depth.
Figure 121: Pulling the handlebars upwards; All Up used
as an example
3 Close the stem clamping lever.
6.5.6.3 Checking the stem stability
Hold handlebars firmly after adjusting the
saddle. Press full body weight on the
handlebars.
The handlebars remain stable in their position.
6.5.6.4 Adjusting the quick release clamping
force
If the handlebar clamping lever stops before
reaching its end position, unscrew the knurled nut.
Tighten the knurled nut on the seat post if the
seat post clamping lever's clamping force is not
effective enough.
Contact your specialist dealer if the clamping
force cannot be set.
Handlebar-stem units are components that may
be replaced after approval by the vehicle or parts
manufacturer.
Only units that are approved for use on e-bikes
may be used to replace the existing ones. A stem
must be replaced if cable and/or line lengths do
not need to be changed.
A change in riding position is allowed within the
original cable length. Furthermore, the load
distribution on the pedelec changes considerably
and may potentially lead to hazardous steering
performance.
Crash caused by incorrectly set clamping
force
Applying excessive clamping force damages the
quick release. Insufficient clamping force will
result in unfavourable transmission of force. This
can cause components to break. This will cause a
crash with injuries.
Never fasten a quick release using a tool (e.g.
hammer or pliers).
To Next Page
Loading...
Need help?
General
