MY23P0a -52_1.0_11.10.2022
272
Troubleshooting, fault clearance and repair
9.4.4 Replacing the riding light
Only use components in the corresponding
power class for replacement.
9.4.5 Adjusting the headlight
The headlight must be positioned so that its
light beam shines on the road 10 m in front of
the pedelec (see Section 6.4).
9.4.6 Checking suspension fork-tyre
clearance
The tyre clearance needs to be checked each time
a suspension fork tyre is replaced.
1 Release pressure from the fork.
2 Press fork together fully.
3 Measure the gap between the top of the tyre
and the fork crown’s lower surface. The gap
must not be less than 10 mm. If the tyre is too
large, the tyre will touch the fork crown’s lower
surface when the fork is fully pressed together.
4 Release pressure on fork and pump it up again
if it is an air suspension fork.
5 Take into account the fact that the gap will be
smaller if there is a guard. Check again to
ensure that there is sufficient clearance for the
tyre.
To Next Page
Loading...
Need help?
General
