Bosch Intuvia 100 User Manual

MY23P0a -52_1.0_11.10.2022
189
Operation
6.18 Using the electric drive system
6.18.1 Switching on the electric drive
system

A sufficiently charged battery has been inserted
into the pedelec.
 The battery is firmly positioned and locked. The
battery key has been removed.
 The speed sensor is connected correctly.
There are two options for switching on the drive
system.
On-Off button (on-board computer)
 Press the On-Off button (on-board computer)
briefly (< 3 seconds).
Figure 174: Position of the On-Off button on the BOSCH
LED Remote
On-Off button (battery)
 Press the On-Off button (battery) briefly.
 All LEDs on the on-board computer will light up
briefly.
 The battery level is displayed in colour by the
battery level indicator (on-board computer) and
the configured level of assistance by the
indicator for the selected level of assistance.
The pedelec is ready to ride.
 If the battery capacity is less than 5%, the
battery level indicator will remain dark. Only
the on-board computer indicates whether the
drive system is switched on or not.
If the drive system is switched on, the drive is
activated as soon as the pedals are moved with
sufficient force (except if the selected level of
assistance is "OFF"). The motor power is based
on the level of assistance selected on the on-
board computer.
6.18.2 Switching off the electric drive
system
As soon as the rider stops pushing the pedals in
normal mode or reaches a speed of 25 km/h, the
drive system switches off the assistance system.
The assistance system starts up again when you
push the pedals and your speed is less than
25 km/h.
The system switches off automatically ten minutes
after the last command.
There are two options for switching off the drive
system manually.
On-Off button (on-board computer)
 Press the On-Off button (on-board computer)
briefly (< 3 seconds).
On-Off button (battery)
 Press the On-Off button (battery).
 The battery level indicator (on-board
computer) and the indicator for the selected
level of assistance go out.
 The pedelec is switched off.
Crash caused by lack of readiness for braking
When it is switched on, the drive system can be
activated by the application of force on the
pedals. There is a risk of a crash if the drive is
activated unintentionally and the brake is not
reached.
 Never start the electric drive system, or switch
it off immediately, if the brake cannot be
reached safely and reliably.
CAUTION
!
1

Bosch Intuvia 100 Specifications

General

Brand	Bosch
Model	Intuvia 100
Category	Bicycle Accessories
Language	English