Bosch Intuvia 100 User Manual

MY23P0a -52_1.0_11.10.2022
197
Operation
6.21.4 Using eShift
eShift refers to the integration of electronic gear
shift systems into the electric drive system.
6.21.4.1 Using eShift with SHIMANO DI2 auto-
matic hub gears
Only applies to pedelecs with this equipment
The automatic SHIMANO DI2 hub gear can be
used in manual or automatic mode. Use the shifter
to change gears in manual mode. In automatic
mode, the shift system changes gear
automatically depending on the speed, pedalling
power and pedalling frequency. You will find how
to switch from automatic to manual mode,
depending on the shifter used, described in your
operating instructions on the on-board computer.
If you use the shifter when in automatic mode, the
gear system will change to the next gear and it will
remain in automatic mode. Manual gear changes
in automatic mode influence shift behaviour in the
gear system and adjust gear changes to ride
performance. If the system is switched on for the
first time when a new, unused wheel is used, the
system will learn the gears first. To do so, the
automatic system changes to the highest/most
difficult gear and then switches through all gears
during the first ride. The new gear is shown briefly
on the on-board computer each time it is changed.
Since the motor detects the gear shift and
consequently reduces motor assistance briefly, it
is possible to switch gears under load or on hills.
If the pedelec is brought to a halt from a speed
greater than 10 km/h, the system can
automatically switch back to a pre-set
START GEAR.
 Adjust the START GEAR in the system
settings if necessary.
6.21.4.2 Using eShift with manual SHIMANO DI2
hub gears
Only applies to pedelecs with this equipment
The new gear is shown briefly on the on-board
computer each time it is changed.
Since the motor detects the gear shift and
consequently reduces motor assistance briefly, it
is possible to switch gears under load or on hills.
If the pedelec is brought to a halt from a speed
greater than 10 km/h, the system can
automatically switch back to a pre-set
START GEAR.
 Adjust the START GEAR in the system
settings if necessary.
6.21.4.3 Using eShift with SHIMANO DI2 auto-
matic hub gears
Only applies to pedelecs with this equipment
Since the motor detects the gear shift and
consequently reduces motor assistance briefly, it
is possible to switch gears under load or on hills.
 The new gear is shown briefly on the on-board
computer each time it is changed.

Bosch Intuvia 100 Specifications

General

Brand	Bosch
Model	Intuvia 100
Category	Bicycle Accessories
Language	English