MY23P0a -52_1.0_11.10.2022
211
Cleaning, maintenance and inspection
7.3.15 Clean brake
7.3.15.1 Clean handbrake
Carefully clean the handbrake with a damp,
soft cloth.
7.3.16 Cleaning the brake disc
1 Put on protective gloves.
2 Spray brake disc with brake disc cleaning
spray.
3 Wipe with a cloth.
7.3.17 Cleaning the belt
1 Dampen a cloth with soapy water. Place the
cloth on the belt.
2 Hold and apply slight pressure while slowly
turning the rear wheel so that the belt passes
through the cloth.
7.3.18 Cleaning the chain
Place newspaper or paper towels underneath to
collect dirt.
1 Slightly dampen a brush with dish-washing
liquid. Brush both sides of the chain.
2 Dampen a cloth with soapy water. Place the
cloth on the chain.
3 Hold and apply slight pressure while slowly
turning the rear wheel, so the chain passes
through the cloth.
4 Wipe off oily, dirty chains thoroughly with a
cloth and degreaser.
5 Care for the chain after cleaning (see
Section 7.4.16).
7.3.18.1 Clean chain, including all-round chain
guard
Clean water hole on the chain guard lower
surface.
Care for the chain after cleaning (see
Section 7.4.16.1).
Notice
Protect brake disc against lubricants and
grease from hands.
Notice
Never use aggressive (acid-based) cleaners,
rust removers or degreasers when cleaning
the belt.
Notice
Never use aggressive (acid-based) cleaners,
rust removers or degreasers when cleaning
the chain.
Never use gun oil or rust remover spray.
Never use chain cleaning devices or chain
cleaning baths.
Have chain with all-round guard cleaned and
cared for during major inspection.
Notice
The chain guard must be removed before
cleaning. Contact specialist dealer.
To Next Page
Loading...
Need help?
General
