Memory
Memory 256 MB
Interface
USB Format Internal port
Mode Full-speed (12 Mbps), high-speed (480 Mbps), bulk transfer
Connector Series B (4-pin)
Ethernet Format Internal port
Specification IEEE 802.3 10Base-T,
IEEE 802.3u 100Base-TX/Auto-Negotiation,
IEEE 802.3ab 1000Base-T/Auto-Negotiation,
IEEE 802.3x Full Duplex
IEEE 802.3az EEE
Protocols SNMP (supports Canon-MIB), HTTP, TCP/IP (IPv4/IPv6)
Ink
For information on the ink the printer supports, see "Ink Tanks."
➔P.540
Paper
For information on the types of paper the printer supports, refer to the Paper Reference Guide. (See "Displaying the
Paper Reference Guide.") ➔ P.363
Paper width For information on the paper widths the printer supports, see "Paper Sizes." ➔P.360
Minimum paper length Rolls 203.2 mm (8.0 in)
Sheets 279.4 mm (11.0 in)
Maximum printable length (*1) Rolls 18 m (19.7 yd)
Sheets 1,600 mm (63.0 in)
Thickness Rolls 0.07–0.8 mm (0.0028–0.031 in)
Sheets 0.07–0.8 mm (0.0028–0.031 in)
Roll maximum outer diameter 150 mm (6 in) or shorter
Supported paper core inner diameter 2 inches / 3 inches
Print area For details, see "Print Area." ➔P.631
*1: Varies depending on the operating system or application.
Roll Holder Set Roll Holder Set RH2-26
Stand Printer Stand ST-27
Stand(*1) Printer Stand ST-27
*1: The stand that is included depends on the region where you purchased the printer.
Print Area
Print Area
A margin required by the printer is added with respect to the size of paper loaded in the printer. Except in borderless
printing, the actual printing area corresponds to the paper size minus the space for this margin.
iPF680
Print Area
User's Guide
Specications Printer Specications
631