Cisco Catalyst 9500 User Manual

Proceed with reload? [confirm]
This example shows how to reload the software on a device at a future date and time:
Device# reload at 02:00 jun 20
Reload scheduled for 02:00:00 UTC Thu Jun 20 2013 (in 344 hours and 53 minutes)
Proceed with reload? [confirm]
Additional References For Performing Device Setup
Related Documents
Document TitleRelated Topic
Command Reference (Catalyst
9500 Series Switches)
Device setup commands
Boot loader commands
Cisco Catalyst 9500 Series
Switches Hardware Installation
Guide
.
Hardware installation
Feature History for Performing Device Setup Configuration
This table provides release and related information for features explained in this module.
These features are available on all releases subsequent to the one they were introduced in, unless noted
otherwise.
Feature InformationFeatureRelease
A device setup configuration can be performed,
including auto configuration of IP address
assignments and DHCP.
Support for this feature was introduced only on the
C9500-12Q, C9500-16X, C9500-24Q, C9500-40X
models of the Cisco Catalyst 9500 Series Switches.
Device Setup
Configuration
Cisco IOS XE Everest 16.5.1a
Support for this feature was introduced only on the
C9500-32C, C9500-32QC, C9500-48Y4C, and
C9500-24Y4C models of the Cisco Catalyst 9500
Series Switches.
Device Setup
Configuration
Cisco IOS XE Fuji 16.8.1a
Use Cisco Feature Navigator to find information about platform and software image support. To access Cisco
Feature Navigator, go to http://www.cisco.com/go/cfn.
System Management Configuration Guide, Cisco IOS XE Amsterdam 17.2.x (Catalyst 9500 Switches)
92
Performing Device Setup Configuration
Additional References For Performing Device Setup

Cisco Catalyst 9500 Specifications

General

Brand	Cisco
Model	Catalyst 9500
Category	Switch
Language	English