Cisco Catalyst 9500 User Manual

Example: Configuring Unicast MAC Address Filtering
This example shows how to enable unicast MAC address filtering and how to configure drop packets that
have a source or destination address of c2f3.220a.12f4. When a packet is received in VLAN 4 with this MAC
address as its source or destination, the packet is dropped:
Device(config)# mac address-table static c2f3.220a.12f4 vlan 4 drop
Additional References for Device Administration
Related Documents
Document TitleRelated Topic
Command Reference (Catalyst 9500 Series
Switches)
For complete syntax and usage information for the
commands used in this chapter.
Feature History for Device Administration
This table provides release and related information for features explained in this module.
These features are available on all releases subsequent to the one they were introduced in, unless noted
otherwise.
Feature InformationFeatureRelease
The device administration allows to configure the
system time and date, system name, a login banner,
and set up the DNS.
Support for this feature was introduced only on the
C9500-12Q, C9500-16X, C9500-24Q, C9500-40X
models of the Cisco Catalyst 9500 Series Switches.
Device AdministrationCisco IOS XE Everest 16.5.1a
Support for this feature was introduced only on the
C9500-32C, C9500-32QC, C9500-48Y4C, and
C9500-24Y4C models of the Cisco Catalyst 9500
Series Switches.
Device AdministrationCisco IOS XE Fuji 16.8.1a
Use Cisco Feature Navigator to find information about platform and software image support. To access Cisco
Feature Navigator, go to http://www.cisco.com/go/cfn.
System Management Configuration Guide, Cisco IOS XE Amsterdam 17.2.x (Catalyst 9500 Switches)
40
Administering the Device
Example: Configuring Unicast MAC Address Filtering

Cisco Catalyst 9500 Specifications

General

Brand	Cisco
Model	Catalyst 9500
Category	Switch
Language	English