Cisco Catalyst 9500 User Manual

Device#
copy tftp:switch-config usbflash0:new-config
Re-executing the Configuration Commands in the Startup Configuration File
To re-execute the commands located in the startup configuration file, complete the task in this section:
Procedure
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
• Enter your password if prompted.
Device> enable
Re-executes the configuration commands
located in the startup configuration file.
configure memory
Example:
Step 2
Device# configure memory
Clearing the Startup Configuration
You can clear the configuration information from the startup configuration. If you reboot the device with no
startup configuration, the device enters the Setup command facility so that you can configure the device from
scratch. To clear the contents of your startup configuration, complete the task in this section:
Procedure
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
• Enter your password if prompted.
Device> enable
Clears the contents of your startup
configuration.
erase nvram
Example:
Step 2
System Management Configuration Guide, Cisco IOS XE Amsterdam 17.2.x (Catalyst 9500 Switches)
236
Managing Configuration Files
Re-executing the Configuration Commands in the Startup Configuration File

Cisco Catalyst 9500 Specifications

General

Brand	Cisco
Model	Catalyst 9500
Category	Switch
Language	English