Cisco Catalyst 9500 User Manual

PurposeCommand or Action
Puts the interface into Layer 3 mode.no switchport
Example:
Step 15
Device(config-if)# no switchport
Specifies the IP address and mask for the
interface.
ip address address mask
Example:
Step 16
Device(config-if)# ip address 10.10.10.1
255.255.255.0
Returns to privileged EXEC mode.end
Example:
Step 17
Device(config-if)# end
(Optional) Saves your entries in the
configuration file.
copy running-config startup-config
Example:
Step 18
Device(config-if)# end
Configuring the Client to Download Files from DHCP Server
You should only configure and enable the Layer 3 interface. Do not assign an IP address or DHCP-based
autoconfiguration with a saved configuration.
Note
Procedure
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Step 1
Device# configure terminal
Enables autoconfiguration with a saved
configuration.
boot host dhcp
Example:
Step 2
Device(conf)# boot host dhcp
System Management Configuration Guide, Cisco IOS XE Amsterdam 17.2.x (Catalyst 9500 Switches)
64
Performing Device Setup Configuration
Configuring the Client to Download Files from DHCP Server

Cisco Catalyst 9500 Specifications

General

Brand	Cisco
Model	Catalyst 9500
Category	Switch
Language	English