Additional References for Application Visibility and Control
Related Documents
Document TitleRelated Topic
Command Reference (Catalyst 9500 Series
Switches)
For complete syntax and usage information for the
commands used in this chapter.
Feature History for Application Visibility and Control in a Wired
Network
This table provides release and related information for features explained in this module.
These features are available on all releases subsequent to the one they were introduced in, unless noted
otherwise.
Feature InformationFeatureRelease
AVC is a critical part of Cisco’s efforts to evolve
its Branch and Campus solutions from being strictly
packet and connection based to being
application-aware and application-intelligent.
Support for this feature was introduced only on the
C9500-12Q, C9500-16X, C9500-24Q, C9500-40X
models of the Cisco Catalyst 9500 Series Switches.
Application Visibility
and Control in a Wired
Network
Cisco IOS XE Everest 16.5.1a
Support for defining QoS classes and policies based
on Network-Based Application Recognition
(NBAR) attributes instead of specific protocols,
was made available, with a few limitations. Only
business-relevance and traffic-class are the
supported NBAR attributes.
Wired Application
Visibility and Control
(Wired AVC)
Attribute-based QoS
(EasyQoS)
Cisco IOS XE Fuji 16.8.1a
Support for DNS flow record was introduced. DNS
flow record uses the DNS Domain-Name as the
collect field for defining the flow record.
DNS flow recordCisco IOS XE Gibraltar
16.12.1
Use Cisco Feature Navigator to find information about platform and software image support. To access Cisco
Feature Navigator, go to http://www.cisco.com/go/cfn.
System Management Configuration Guide, Cisco IOS XE Amsterdam 17.2.x (Catalyst 9500 Switches)
163
Configuring Application Visibility and Control in a Wired Network
Additional References for Application Visibility and Control
To Next Page
Loading...
Need help?
General