Cisco Catalyst 9500 User Manual

TestPortTxMonitoring
This test monitors the transmit counters of a connected interface. It verifies if a connected port is able to send
packets or not. This test runs every 150 seconds.
DescriptionAttribute
Nondisruptive.Disruptive or Nondisruptive
Do not disable. This can be run as a health-monitoring
test and also as an on-demand test.
Recommendation
On.Default
Cisco IOS XE Gibraltar 16.10.1.Intitial release
Displays a syslog message if the test fails for a port.Corrective action
All modules.Hardware support
How to Configure Online Diagnostics
The following sections provide information about the various procedures that comprise the online diagnostics
configuration.
Starting Online Diagnostic Tests
After you configure diagnostic tests to run on a device, use the diagnostic start privileged EXEC command
to begin diagnostic testing.
After starting the tests, you cannot stop the testing process midway.
Use the diagnostic start switch privileged EXEC command to manually start online diagnostic testing:
Procedure
PurposeCommand or Action
Starts the diagnostic tests.diagnostic start switch number test {name |
test-id | test-id-range | all | basic | complete |
minimal | non-disruptive | per-port}
Step 1
The switch number keyword is supported only
on stacking device.
Example:
You can specify the tests by using one of these
options:
Device# diagnostic start switch 2 test
basic
• name: Enters the name of the test.
• test-id: Enters the ID number of the test.
• test-id-range: Enters the range of test IDs
by using integers separated by a comma
and a hyphen.
• all: Starts all of the tests.
System Management Configuration Guide, Cisco IOS XE Amsterdam 17.2.x (Catalyst 9500 Switches)
199
Configuring Online Diagnostics
How to Configure Online Diagnostics

Cisco Catalyst 9500 Specifications

General

Brand	Cisco
Model	Catalyst 9500
Category	Switch
Language	English