Cisco Catalyst 9500 User Manual

Example
In the following example, a device is configured to download the host configuration file named
hostfile1 and the network configuration file named networkfile1. The device uses TFTP and the
broadcast address to obtain the file:
Device# configure terminal
Device(config)# boot host tftp:hostfile1
Device(config)# boot network tftp:networkfile1
Device(config)# service config
Device(config)# end
Device# copy system:running-config nvram:startup-config
Feature History for Managing Configuration Files
This table provides release and related information for features explained in this module.
These features are available on all releases subsequent to the one they were introduced in, unless noted
otherwise.
Feature InformationFeatureRelease
Configuration files contain the Cisco IOS software
commands used to customize the functionality of
your Cisco device. Commands are parsed
(translated and executed) by the Cisco IOS software
when the system is booted (from the startup-config
file) or when you enter commands at the CLI in a
configuration mode.
Support for this feature was introduced only on the
C9500-12Q, C9500-16X, C9500-24Q, C9500-40X
models of the Cisco Catalyst 9500 Series Switches.
Managing Configuration
Files
Cisco IOS XE Everest 16.5.1a
Support for this feature was introduced only on the
C9500-32C, C9500-32QC, C9500-48Y4C, and
C9500-24Y4C models of the Cisco Catalyst 9500
Series Switches.
Managing Configuration
Files
Cisco IOS XE Fuji 16.8.1a
Use Cisco Feature Navigator to find information about platform and software image support. To access Cisco
Feature Navigator, go to http://www.cisco.com/go/cfn.
System Management Configuration Guide, Cisco IOS XE Amsterdam 17.2.x (Catalyst 9500 Switches)
243
Managing Configuration Files
Feature History for Managing Configuration Files

Cisco Catalyst 9500 Specifications

General

Brand	Cisco
Model	Catalyst 9500
Category	Switch
Language	English